*These Tie rods are built Specifically for the 2011-2019 GM HD Trucks Equipped with a Fabtech RTS Style Lift kit that utilizes an alternate size outer rod end only!

*Will Not Fit an OEM Knuckle. 

Attention; With the installation of an oversized Tie Rod, modification or alteration of the sway bar end link may be required. 

Engineered exclusively for the extreme demands of today's heavy duty truck.  Built with pride in the USA to work with stock or modified suspension. Kryptonite tie rods will fit any 2011-2019 2500/3500 GM HD Truck that has the center link mounted in the factory location and has Fabtech aftermarket knuckles. Using superior components and engineering, these tie rods easily outperform the competition.This pair is for use with your factory center link.
 

In recent laboratory strength tests we applied enough pulling pressure to rip apart the OEM, Aftermarket, and Kryptonite Death Grip tie rods. The OEM tie rods fail at 9000 pounds of pressure.  The much larger diameter aftermarket tie rods designed to fit lifted suspension trucks, failed at 17000 pounds of pressure. Kryptonite Death Grip tie rods held up to an incredible 21000 pounds of pressure before pulling apart.

All of our ball joints and rod ends come pre-greased with premium Chevron Ultra EP2 Grease and are ready to install. Servicing will be done every 7-10k miles. (A small amount of grease is needed per joint, do not over grease)

(Kryptonite No Fine Print Lifetime warranty)-Kryptonite steering and suspension components are warrantied for life to their original purchaser. This warranty is against any manufacturer defects, premature wear or breakage. Race it, jump it, off road it, wreck it, lift it, I think you get it? We don't care. If you can break it we will replace it. In recent laboratory strength tests we applied enough pulling pressure to rip apart the OEM, Aftermarket, and Kryptonite Death Grip tie rods. The OEM tie rods fail at 9000 pounds of pressure.  The much larger diameter aftermarket tie rods designed to fit lifted suspension trucks, failed at 17000 pounds of pressure. Kryptonite Death Grip tie rods held up to an incredible 21000 pounds of pressure before pulling apart.

All of our ball joints and rod ends come pre-greased with premium Chevron Ultra EP2 Grease and are ready to install. Servicing will be done every 7-10k miles. (A small amount of grease is needed per joint, do not over grease)

(Kryptonite No Fine Print Lifetime warranty)-Kryptonite steering and suspension components are warrantied for life to their original purchaser. This warranty is against any manufacturer defects, premature wear or breakage. Race it, jump it, off road it, wreck it, lift it, I think you get it? We don't care. If you can break it we will replace it. 

• Heat treated chromoly nickel outer studs.
• Bulletproof, all steel inner ball sockets. 
• Solid 1 1/4" Hexagon steel body.
• Left and Right hand jam nuts for the ultimate adjust ability.