NO DRILLING OR MODIFICATIONS REQUIRED!! SIMPLY BOLT ON!! 

NOTE: This does require drilling your track bar mounting hole at the frame side drop bracket to a 1” hole, as we use a 1” grade 8 bolt at that end (extremely beefy and much stouter than the factory setup)  

• The frame end re-uses the factory track bar bolt and we supply custom misalignments to retain the factory hardware so no drilling is required to change bolt size!

• We supply a custom machined and slotted tapered sleeve at the axle end to insert into the axle bracket to convert it to a 3/4" bolt. The slot ensures that as the bolt is tightened, it cinches into the factory tapered hole as tight as possible.

• (1) Heavy Wall Double Adjustable track bar

• (1) Bracket Plate

• (1) Mounting Puck

• (2) 1.25” Teflon lined heims with misalignments and jam nut.

• (2) 3/4" grade 8 bolt with washers and nylock nut

• (1) Double shear bracket at axle end to convert to heim joint

• (2) Misalignment Spacers - axle end

• (2) Custom misalignment spacers at frame end to retain factory bolt - frame end

• All grade 8 hardware